Cold-Applied Primer-Free Self-Healing Viscoelastic Corrosion Protection Tape and Visco Elastic Wrap for Pipeline Inner Protection

150 mm * 10 m Roll | Primer-Free, Self-Healing Corrosion Barrier

Our Cold-Applied Viscoelastic Corrosion Protection Tape (Inner Wrap) is a high-performance, primer-free protective tape engineered for the long-term corrosion protection of pipelines, field joints, fittings, and complex geometries. Supplied in a convenient 150 mm width * 10 meter length roll, this inner wrap tape is applied directly to prepared steel or compatible coatings without heat, primer, or special equipment.

Formulated with advanced viscoelastic adhesive technology, the tape cold-flows into surface irregularities, self-heals minor damages, and forms a continuous, watertight barrier against moisture, oxygen, and corrosive soils. It serves as the critical inner layer of a multi-layer corrosion protection system, delivering reliable performance in buried, immersed, and above-ground service conditions.

The Cold-Applied Viscoelastic Corrosion Protection Tape (Inner Wrap) is designed as the inner protective layer of a complete corrosion protection system. Typical system configuration for pipeline field joints and complex geometries:

The inner wrap tape can be applied directly to blast-cleaned steel (Sa 2½ or equivalent) or over a compatible primer, depending on project specification. For applications requiring additional mechanical protection, the inner wrap is overwrapped with a compatible viscoelastic outer tape.

Values are indicative and shall be confirmed against the specific product data sheet.

• Pipeline field joints – Girth welds, tie-ins, and repair areas

• Fittings and flanges – Valves, tees, elbows, and flanged connections

• Tank bottom chime edges – Concrete-to-steel interfaces

• Buried and immersed pipelines – Onshore and offshore environments

• Coating rehabilitation – Repair of damaged PE, PP, FBE, and bitumen coatings

• Water and sewerage pipelines – Joint protection and sealing

1. Surface Preparation: Clean the steel surface to Sa 2½ or equivalent; remove dust, oil, and contaminants. Surface should be dry and frost-free.

2. Position Tape: Starting at one end, apply the tape spirally around the pipe with the specified overlap (typically 50% or per project specification).

3. Press and Conform: Press the tape firmly against the surface by hand or with a roller to ensure intimate contact and initiate cold-flow.

4. Overwrap (if specified): Apply the outer wrap tape over the inner wrap for additional mechanical protection.

5. Inspect: Visually inspect for voids, lifted edges, or incomplete coverage. No curing time is required before backfill.